Download Print this page

Panasonic CQ-VW220W Installation Instructions Manual page 9

Advertisement

Note:
¡ To prevent from damage to the unit, be sure to follow the wiring diagrams below.
¡ Be sure to fully plug in the connectors. Secure them with clamps and tapes.
¡ All other installation methods require the use of dedicated metal fittings. Consult with a qualified servicing engineer or
your dealer if other methods are required.
¡ Installation of this product may interfere with the grounding properly. In such a case, connect the ground lead of the
external equipment to be connected to the mounting bolt r that secures this product.
¡ The pre-out connector is used exclusively with an external amplifier. Accordingly, do not connect the audio input ter-
minal or any other external devices to this connector.
Radio Antenna Connector (RADIO ANT IN)
System-up Connector
To external devices equipped with system-up connector.
(CY-BT200N/CY-TUP133W/CY-TUN133W, option) Please do not connect other device to this connector.
RGB Connector
To the Panasonic Car Navigation System (available in future).
Navi Mute Lead (Orange)
Connect to the Navi Mute Lead of the Panasonic car
navigation system. (available in future)
Motor Antenna Relay Control Lead (Blue)
(To motor antenna) (Max. 100 mA)
This lead is not intended for use with a switch actuated power
antenna.
Side Brake (Parking Brake) Connection Lead (Bright green)
Be sure to wire the side brake (parking brake) for safety and pre-
venting accidents.
(a
page 10)
SIDE BRAKE
External Amplifier Control Power Lead (Blue/white stripe)
To an external amplifier.
Note:
¡Use the power control lead of the TV tuner for TV
tuner connection.
¡Connect both the power control lead of the TV tuner
and the amplifier control connector of the external
amplifier when the TV tuner and external amplifier are
connected at the same time.
Reverse Lead
(Violet/white stripe)
When connecting the rear view camera, use the reverse
lead.
(a
page 13)
Power Lead (Red)
To ACC power, +12 V DC.
ACC
Battery Lead (Yellow)
To the car battery, continuous +12 V DC.
BATTERY 15A
Ground Lead (Black)
To a clean, bare metallic part of the car chassis
: This book refers to connections to the Panasonic
car navigation system that will come onto the
market in the future. Descriptions regarding the
car navigation system are boxed with a dotted line.
u
Power Connector
Front Right + (Gray)
Front Right – (Gray/black stripe)
Front Left + (White)
Front Left – (White/black stripe)
Rear Right + (Violet)
Rear Right – (Violet/black stripe)
Rear Left + (Green)
Rear Left – (Green/black stripe)
Speaker connections
• Do not connect more than one speaker to one set of
speaker leads (except for connecting to a tweeter).
Use of speakers which do not match the speci-
fications can cause burning, smoking or dam-
age of the speakers.
• Do not use a 3-wire type speaker system having a
common earth lead.
8
9
CQ-VW220W

Advertisement

loading