Panasonic CQ-VW220W Installation Instructions Manual page 6

Installation
Mounting and removing the Main Unit
❏ Mounting Procedures (A)
5
Note:
¡The car model, installation conditions and combination
of the units used may impose some restrictions on
opening and closing the monitor as well as on the
angle and position to which the monitor can be adjust-
ed.
u Power Connector
Method for Fixing the Rear of the Unit
(a) Using the Rear Support Strap (option)
Fire wall of car
Rear Support Strap
(option, YEFG044C002)
Tapping Screw
(5 mmø x 16 mm)
(option, XTT5+16AFN)
To the unit
r Mounting Bolt
6
CQ-VW220W
(continued)
(When using Mounting Collar w)
q
w
r Mounting Bolt
(5 mmø)
e
r
t
3 ø
mm
Hex. Nut (5 mmø)
(option, YEJN99023)
(5 mmø)
IMPORTANT
When this unit is installed in dashboard, ensure that there
is sufficient air flow around the unit to prevent damage
from overheating. Do not block any ventilation holes on
the unit.
q
Insert the Mounting Collar w into the dash-
board, and bend the mounting tabs out with
a screwdriver.
w
Establish the rear connection of the unit.
After fixing Power Connector u, fix the rear
of the unit to the car body by either method
(a) or (b).
e Insert the unit into Mounting Collar w.
Secure the clamp plate of Mounting Collar w
to the hook.
r
Insert Trim Plate q.
t
After installation reconnect the negative (–)
battery terminal.
(b) Using the Rubber Cushion (option)
Rubber Bushing
(option)
Rear Support
Bracket
(Provided on
To the unit
the Car)
r Mounting Bolt
(5 mmø)
Snapping point