Outdoor Unit; Remote Controller; Name Of Each Part; Setting Current Time - Mitsubishi Electric MSC-GE20VB Operating Instructions Manual

● OPERATING INSTRUCTIONS ●
N
AME OF EACH PART
Indoor unit
Air cleaning
fi lter (Option)
Heat exchanger
Air outlet
Air fi lter
(Catechin air fi lter
with deodorizer)
Vertical vane
Fan
Horizontal vane

Outdoor unit

Outdoor units may be different in appearance.

Remote controller

Operation display
section
COOL & HEAT type
COOL ONLY type
ON/OFF
(operate/stop)
button
FAN speed
control button
Page 5
Operation
select
button
Page 4
ECONO
COOL
button
Page 6
VANE
control button
Page 5
Use the remote controller provided with the unit only.
Do not use other remote controllers.
If two or more indoor units are installed in proximity to one another, an indoor
unit that is not intended to be operated may respond to the remote controller.
En-3
Front panel
Air inlet
Emergency
operation
switch
Page 4
Display section
Operation Remote control
Indicator
receiving section
lamp
Air inlet (back and side)
Piping
Drainage hose
Air outlet
Drain outlet
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard from
the indoor unit when the
signal is received.
Temperature buttons
Page 4
Off-timer button
Page 6
On-timer button
Page 6
TIME set buttons
Pages 3, 6
HR. button
MIN. button
CLOCK button
Page 3
RESET button
Page 3
Lid
Slide down to open
Remote controller
holder
• Install the remote control-
ler holder to a place where
the signal can be received
by the indoor unit.
P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or
turn the breaker on.
How to set the type
This remote controller setting needs to be switched according to the type of air
conditioner (COOL & HEAT or COOL ONLY).
Position of the slide switch
<COOL & HEAT type>
• Incorrect setting causes a malfunction. Check the correct setting as shown
above.
Installing the remote controller batteries
4.
Press RESET
1.
Remove the front lid
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.

Setting current time

1.
Press CLOCK
3.
Press CLOCK again
• Press CLOCK gently using a thin instrument.
Slide switch
<COOL ONLY type>
2.
Insert AAA
alkaline batteries
3.
Install the front lid
2.
Press the TIME set buttons to
set the time
Each time / is
pressed, the set time increases
by 1 hour/minute.