Front Roller; Removing - TiLite TRA AERO T Owner's Manual

Front Roller

Removing

Tools Needed:
• 1/8" Allen Wrench
With an open loop footrest:
1. Remove the two Allen screws. See Figure 13-7.
2. Remove the Front Roller assembly.
I WARNING
The threads on the Allen screws that connect the Front
Roller to the footrest tube are treated with Loctite
medium strength thread lock. If you loosen either Allen
screw, you MUST remove and reapply Loctite
equivalent medium strength thread lock. If you ignore this
Warning, your Front Roller could fall off and you could fall,
tip over or lose control of the wheelchair and seriously
injure yourself or others or damage the wheelchair.
With an angle adjustable footrest:
1. Remove the Allen screws that secure the Front Roller
to the roller plate. See Figures 13-8 and 13-9.
2. Remove the Allen screws that secure the footplate and the clamp to the roller plate.
3. Reassemble the angle adjustable footplate as shown in Figure 3-6.
Note: If removing the Front Roller from an angle adjustable footrest, you will need to order new, shorter Allen screws
and washers to secure the footplate to the clamp.
Aero T/TRA Owner's Manual
Figure 13-6
Mounting
Camber Tube
Clamp
Anti-Tip Mount
5 Threaded
Holes
Allen
Screw
Receiver
242 , a
® ®
242 or an
® ®
CHAPTER 13: ANTI-TIPS
Allen Screw
Allen Screw
Figure 13-7
Front Roller
13-5
Front
Roller
Allen
Screws
OM_Aero T_TRA_0414RevB