Adjusting The Height; Transfer Loop; Adjusting The Armrest Height; Removing - TiLite TRA AERO T Owner's Manual

CHAPTER 5: ARMRESTS

Adjusting the Height

Tools Needed:
• 5/32" Allen Wrench
1. Remove the armrest from the receiver.
2. Remove the Allen screw and washer securing the
armrest stop. See Figure 5-3.
3. Reassemble the armrest stop in the desired location on
the armrest (in 3/4" increments).
4. Securely tighten the Allen screw.
5. Reinstall the armrest in the receiver.
Desk Arm with Rigid Side Guard and Desk Arm with Rigid Side Guard and Transfer
Loop
I WARNING
Make sure the armrest is securely engaged in the desk arm housing (see Figure 5-4), before applying weight to
the armrest. If you ignore this Warning, you could fall, tip over or lose control of the wheelchair and seriously injure
yourself or others or damage the wheelchair.
Note: Never lift your chair using the Desk Arms.

Adjusting the Armrest Height

1. Pull up on the height adjustment lever to permit the armrest to be raised or lowered to the desired height. See
Figure 5-4.
2. After repositioning the armrest to the desired height, release the height adjustment lever, pressing the handle
against the desk arm housing to lock the armrest in that position. The positioning holes are in 1/2" increments.

Removing

1. To remove the desk arm assembly, press and hold the release lever. See Figure 5-4.
2. While holding the release lever, lift the desk arm assembly to remove it from the desk arm mount. See Figure 5-5.

Replacing

Slide the desk arm housing into the desk arm mount. See Figure 5-5.
I WARNING
Make sure the desk arm housing securely locks in the desk arm mount (see Figure 5-5), before applying weight to
the armrest. If you ignore this Warning, you could fall, tip over or lose control of the wheelchair and seriously injure
yourself or others or damage the wheelchair.
Aero T/TRA Owner's Manual
Adjusting the Height
Washer
Allen Screw
5-2
Figure 5-3
Armrest
Armrest
Stop
Receiver
OM_Aero T_TRA_0414RevB