Advertisement
Compatibility
The LightwaveRF Slave Dimmer is compatible with:
• Standard mains voltage incandescent & low energy
incandecent lighting (min 40W, max 250W)
• Dimmable Electronic Low Voltage Transformers
• GU10 and equivalent HI spot mains halogen bulbs
The 1 gang LightwaveRF Slave Dimmer is NOT
compatible with:
• Wire-wound transformers (generally older models)
• Electric Motors
Please Note:
• Master units must be installed
• Units can ONLY be operated manually: the slave unit
will not operate with a LightwaveRF RF remote.
For a full, up to date list of all compatible bulbs,
including LEDs and CFLs, please refer to
www.lightwaverf.com.
Installation Guide
1. Turn o mains electrical supply.
2. Ensure that the wall (back) box has a minimum
depth of 25mm.
3. Remove the existing light switch and disconnect
the wiring.
4. Gently remove plate by inserting a at screwdriver
into the slots/s of the plate and lift away from the
unit.
Advertisement
