Paper shredder HSM 411.2 1. Proper use, warranty 3. Safety instructions The document shredder is to be used for • Read all instructions before start-up of the shredding paper. Depending on the cutting paper shredder. Save these instructions for type, small quantities of the following materials later use.
Page 4
Paper shredder HSM 411.2 Before taking off the cover, 4. Installation changing the location, cleaning • This paper shredder should never be placed or anything else other than near or over a radiator or heat source. normal operation turn off and •...
Page 5
Paper shredder HSM 411.2 5. Start-up Destroying credit cards, CDs, discs or DAT cassettes: Switching the paper shredder on Cross cut machines: Fold the safety element down (only for cut • Set mains switch at rear of paper ting types 3.9 x 50 mm and 1.9 x 15 mm), shredder to „I“.
Paper shredder HSM 411.2 6. Troubleshooting Electric motor overheated • Red LED on membrane key Pa per jam board lights. • Paper shredder switches off au You have fed in too much paper. tomatically. • Paper shredder jammed. • Allow paper shredder to cool •...
Paper shredder HSM 411.2 7. Maintenance and care When the cutting capacity drops or the noise increases: Cleaning: • Lift the inspection door on the • Switch off the shredder, pull out the mains top of the device and spray spe...
Low voltage directive 73 / 23 / EWG The manufacturer HSM Pressen GmbH + Co. KG, Bahnhofstraße 115, D-88682 Salem declares herewith, that the paper shredders HSM 411.2 aboved mentioned correspond with the EC Machine Directive inclu ding all relevant modifications.
Need help?
Do you have a question about the HSM 411.2 and is the answer not in the manual?
Questions and answers