Toro TimeCutter SS 4216 74616 Operator's Manual page 12

Blade Control Switch (Power Take-Off)
The blade control switch, represented by a power take-off
(PTO) symbol, engages and disengages power to the mower
blades (Figure 5).
Motion Control Levers and Park
Position
The motion control levers are speed sensitive controls of
independent wheel motors. Moving a lever forward or
backward turns the wheel on the same side forward or in
reverse; wheel speed is proportional to the amount the lever
is moved. Move the control levers outward from the center
to the park position and exit the machine (Figure 16). Always
position the motion control levers into the park position
when you stop the machine or leave it unattended.
Smart Speed™ Control System Lever
The Smart Speed™ Control System lever, located below the
operating position, gives the operator a choice to drive the
machine at two speed ranges, high and low (Figure 6).
1. Smart speed lever
Fuel Window
The fuel window located on the left hand side of the machine
can be used to verify the presence of gasoline in the tank
(Figure 7).
1
G014475
Figure 6
G014521
1
1. Fuel presence window
Height-of-Cut Lever
The height of cut lever allows the operator to lower and
raise the deck from the seated position. When the lever is
moved up, toward the operator the deck is raised from the
ground and when moved down, away from the operator it is
lowered toward the ground. Only adjust the height of cut
while machine is not moving (Figure 4).
12
Figure 7