Toro TimeCutter SS 4216 74616 Operator's Manual page 18

Figure 16
1. Park (brake) position
2. Center unlock position
3. Forward
Using the Smart Speed™ Control
System
The Smart Speed™ Control System lever, located below the
operating position (Figure 17), gives the operator a choice to
drive the machine at two ground speed ranges, high and low.
Figure 17
1. Smart speed lever
To change speeds:
1. Move the motion control levers to neutral and outward
to the park position; disengage the blade control switch.
4. Backward
5. Front of machine
1
G014475
WARNING
Removing your hands from the motion control
levers while the machine is in motion can
result in a loss of control causing harm to you
or bystanders.
Always stop the machine and move the motion
control levers to the park position before
adjusting the Smart Speed™ Control System.
2. Adjust the lever to the desired position.
Forward
1. Move the levers to the center, unlocked position.
2. To go forward, slowly push the motion control levers
forward (Figure 16).
To go straight, apply equal pressure to both motion
control levers (Figure 16).
To turn, release pressure on the motion control lever
toward the direction you want to turn (Figure 16).
The farther you move the motion control levers in
either direction, the faster the machine will move in
that direction.
To stop, pull the motion control levers to neutral.
Backward
1. Move the levers to the center, unlocked position.
2. To go backward, look behind you and down as you
slowly pull the motion control levers rearward (Figure
19).
18
G008952
Figure 18