Kenwood DNX5220 Installation Manual page 4

Connection
Connector A
8 6 4
7 5 3
8 6 4
7 5 3
Connector B
Connect either to the power control terminal when using the optional
power amplifier, or to the antenna control terminal in the vehicle.
|
4
DNX5220BT/ DNX5220
Ground wire (Black)
Battery wire (Yellow)
2
1
Ignition wire (Red)
2
1
Connect to the vehicle's parking
brake detection switch harness.
Parking sensor wire (Light Green)
PRK SW
For the sake of safety, be sure to connect the parking sensor.
Connect to vehicle's reverse lamp harness when
using the optional rear view camera.
Connect to the terminal that is grounded when either
the telephone rings or during conversation.
If no connections are made, do not let the cable come out from the tab.
(Orange/White)
Reveres sensor wire (Purple/White)
Steering remote control input
(Light Blue/Yellow)
To steering remote
To use the steering wheel remote control feature, you need to an
exclusive remote adapter (not supplied) matches your car is required.
When this terminal is not in use, leave its cap on.
Power control/ Motor antenna control wire
(Blue/White)
Antenna Cord
Dimmer control wire (Orange/White)
ILLUMI
Mute wire (Brown)