LG 32LM6200 Service Manual page 13

Aging time Cool
GP4
(Min) x
269
1 0-2 280
2 3-5 279
3 6-9 277
4 10-19 276
5 20-35 274
6 36-49 272
7 50-79 271
8 80-119 270
9 Over 120 269
5.4 EYE-Q function check
Step 1) Turn on TV
Step 2) Press EYE key of Adj. R/C
Step 3) Cover the Eye Q II sensor on the front of the using your hand
and wait for 6 seconds
Step 4) Confirm that R/G/B value is lower than 10 of the "Raw Data
(Sensor data, Back light )" . If after 6 seconds, R/G/B value is
not lower than 10, replace Eye Q II sensor
Step 5) Remove your hand from the Eye Q II sensor and wait for 6
seconds
Step 6) Confirm that "ok" pop up. s
If change is not seen, replace Eye Q II sensor
5.5 Local Dimming Function Check
Step 1) Turn on TV
Step 2) At the Local Dimming mode, module Edge Backlight moving
right to left
Back light of IOP module moving
Step 3) confirm the Local Dimming mode
Step 4) Press "exit" Key.
5.6 Magic Motion Remocon test
Copyright © LG Electronics. Inc. All rights reserved.
Only for training and service purposes
Medium Warm
y x y x
273 285 293 313
287 296 307 320
285 295 305 319
284 293 304 317
283 292 303 316
280 290 300 314
277 288 297 312
275 287 295 311
274 286 294 310
273 285 293 309
-equipment : RF Remocon for test, IR-KEY-Code Remocon for test
y
-You must confirm the battery power of RF-Remocon before test
329
(recommend that change the battery per every lot)
337
-Sequence (test)
335
a)if you select the 'start key(OK)' on the controller, you can
334
pairing with the TV SET.
333
b)You can check the cursor on the TV Screen, when select the
330
'OK Key' on the controller
327
c) You must remove the pairing with the TV Set by
325
'Mute + OK Key' on the controller
324
323
5.7 3D function test
(Pattern Generator MSHG-600, MSPG-6100 [SUPPORT HDMI1.4])
* HDMI mode NO. 872 , pattern No.83
1) Please input 3D test pattern like below
(HDMI mode NO. 872 , pattern No.83)
2.When 3D OSD appear automatically ,
then select green button.
3. Don't wear a 3D Glasses,
Check the picture like below .
5.8 3D Depth function TEST
5.9 Wi-Fi Test(LM6200 not support
Wi-Fi)
5.10 LNB voltage and 22KHz tone
check (only for DVB-S/S2 model)
Test method
- 13 -
LGE Internal Use Only