Function 32: Extension Feature Authorization - ESI IVX 128 Plus Installer's Programming Supplement

Hide thumbs Also See for IVX 128 Plus:
Table of Contents

Advertisement

13. Operator translation
Extension 0 (Operator) programming requires:
• Programming call forwarding for day and night mode
• Entering the extension number, department, mailbox or branch ID to which calls are to be directed
when someone dials 0.
Default: 100.
The Remote Phone will become active, in a local mode, when extension definition programming is
complete for the assigned extension. The Remote Phone is ready for installation at the remote site.
Important: If the Remote IP Feature Phone is not connected to the IVX 128 Plus network at the
time of extension definition programming, critical addressing parameters will not have
been programmed into the Remote Phone. Connect the Remote Phone to the network
and repeat Function 31 extension programming for this extension, pressing # at the
appropriate times to confirm previously entered values. (Performing this step again
causes the IVX 128 Plus to send the programming information to the Remote IP
Feature Phone.)

Function 32: Extension feature authorization

What's new: Two features, auto-page and external forwarding (including forwarding to toll numbers).
1.
2.
3.
Ext.
Name
Call
wait
XXX
Default
Y
100
Jane
Y
101
Roger
Y
102
Sally
Y
Bill
Y
110*
10. Auto-page — Lets the user turn auto-page (defined below) on or off at his/her station.
Note: This feature is used in conjunction with the directory names recorded in Function 62 and is
not active until a directory name is recorded for the extension.
If the station user has his/her mailbox set to answer with personal greeting 3 and a caller presses 3
to page that user, this feature automatically pages the station user in the page zones entered in
Function 31. If no page zone is entered, all IVX Digital Feature Phones on the system are paged.
Default: Disabled.
Note: When auto-page is enabled, IVX 128 Plus will use the last installed idle digital port to
perform the page. Therefore, if a phone is on the last installed port (e.g., X111 on a system
with only a 612 Card), the phone's user may experience a brief delay in telephone operation
if he/she picks up the handset (or presses SPEAKER) during the auto-page.
* An example of an analog phone.
4.
5.
6.
7.
DND
AA
Rec.
Svc.
block
obs.
Y
N
Y
Y
N
Y
Y
N
Y
Y
N
N
N
N
8.
9.
Toll
Sys.
allow
spd. dial
N
Y
Y
N
Y
Y
N
Y
Y
Y
Y
Y
Y
IVX 128 Plus: additional features
10.
11.
12.
Auto
Ext.
Fwdg. to
page
fwdg.
toll nos.
N
N
N
Y
N
N
N
N
N
Y
N
N
N
N
N
11

Advertisement

Table of Contents
loading

Table of Contents