Table of Contents
Advertisement
IVX 128 Plus: additional features
Function 163: System-wide hold
Used in conjunction with station CO line key appearances. This function — when enabled — allows
station users to press the HOLD key to place a caller on hold so that any station programmed with CO
line key appearances can retrieve the call. After the user presses HOLD, the caller's CO line will blink
green at the station placing the call on hold and red at all other stations. Any user who has a key
blinking due to this call can retrieve the call from hold by pressing the blinking key. (For stations
without line key appearances, placing a caller on hold puts him on exclusive hold only.)
Default: Disabled.
Function 21: CO line programming
What's new: The capability to name CO lines; PRI programming.
1.
CO
1
The steps are:
Choose the CO lines to program.
1.
Note: If performing T1 programming (Function 2121), set trunk emulation as explained in the
Installation Manual before proceeding to step 2.
Name the CO line (optional — up to 10 alphanumeric characters).
2.
To retain default values, press #. [See below for more details.]
Follow the remaining steps in the manual for the respective function, either Function 211 (analog
3.
CO line programming) or Function 2121 (T1 CO line programming).]
Note: Function 213 (PRI programming) is detailed in this addendum.
Naming the CO lines (step 2, above)
During this step, you can name the CO lines you are programming. Each name can contain up to 10
alphanumeric characters. This step is optional. If you press # during this step, the default names (e.g.,
Line 1, Line 2, etc.) will be retained. If you select multiple CO lines to program, the name field will be
left blank; you can either press # at this point to keep all of the lines' default names or, by entering a
name, assign the same name to all selected CO lines. If you want to change an already programmed
name to the default value, press HOLD to delete the name and then press # while the field is blank;
this restores the default values for all selected lines.
If used in conjunction with Caller ID, this feature causes the Caller ID name to appear on the top line,
and the CO line name on the bottom line, for five seconds after someone answers a call on that line.
After that, a call timer appears on the top line's right side and, on the bottom line, the CO line name is
replaced by the usual lines-in-use display. If Caller ID is not enabled, the CO name will appear on the
top line of the display and the CO line use indications will be on the bottom line.
Default: Line numbers.
2
2.
3.
Name
OUT
CO line 1
9
4.
Ring 1
Ring 3
Ring 5
X100
X100
X100
Ring 9
ID1
Advertisement
Table of Contents
