Navigation Setup; Dsp Bypass Control (Dnx7 Series) - Kenwood DDX8046BT Instruction Manual

Navigation Setup

Navigation Setup
You can set Navigation parameters.
1 Display the Navigation Setup screen
> >
Touch [ ] [
(page 78)
2 Set each item
[NAV Interrupt Speaker] Selects
speakers used for voice guidance of the
navigation system. (
"Front L": Uses the front left side
speaker for voice guidance.
"Front R": Uses the front right side
speaker for voice guidance.
"Front All": Uses both front speakers for
voice guidance.
[NAV Voice Volume] Adjusts the
volume for voice guidance of the
navigation system.
( DNX series: "25", DDX series: "21")
[NAV Mute] Mutes the volume of rear
speakers during voice guidance of the
navigation system. (
When turned "ON", the volume level
drops for voice guidance.
[Navigation Input] Selects a navigation
system connection. (
series only)
"RGB": Allows the Kenwood's
Navigation System to connect via its
interface cable.
"AV-IN": Allows a third-party navigation
system to connect via the AV INPUT1
DDX series DDX896/ DDX8046BT
> >
] [Navigation].
"Front All")
"ON")
"RGB") (DDX
port.
"OFF": Must be used if no navigation
system is connected. (The navigation
display is cancelled when the AV
source is switched.)
[On Screen Navigation] Sets an
on-screen display of the navigation
screen. ( "OFF") (DDX series only)
"Auto": Information is displayed for 5
seconds when updated. (Example :
when the track/file/song has changed
to the next one.)
"OFF": Information is not displayed.
⁄
• [On Screen Navigation]
It can be set only when [Navigation Input] is set
to "AVIN".

DSP Bypass Control (DNX7 series)

DSP Bypass Control (DNX7 series)
Temporarily bypassing DSP (Digital Signal
Processor) System.
1 Display the Audio SETUP screen
> >
Touch [ ] [
(page 78)
2 Set the DSP Select
[Bypass] There is no effect by DSP.
[Through] There is an effect by DSP.
⁄
• When the mode is set to [Bypass], DSP System
cannot be adjusted.
> >
] [Audio SETUP].
Next page 3 Next page 3
English 93