Jenn-Air CCGX2420 Installation Manual page 10

2£0Edwar(]s 8 !reet,SE
61aveian_, Tennessee 37311
Tei: a 234723333
Fax: 4 23,_78-671E1
C. SECURING COOKTOP TO COUNTER
1. Apply loam tape (loam tape is used on glass top models only):
a. Remove the glass top unit from the carton and place it upside down over two soft pads making sure
control knobs do not interfere with any surface.
b. Peel off the hacking paper from the foam gasket provided with the unit and stick the adhesive
backed tape to the glass along its edge.
2. Position cooktop in cutout.
3. From inside cabinet, position tie-down bracket underneath cutout.
4. Attach with screws provided to sma|[ hole in bottom of burner box bottom. NOTE: Smal! hole may
sometimes be partially covered with enamel. The mounting screws provided should be adequate for most
countertop thickness. If unusually thick countertop is encountered a longer mounting screw must be used.
_) _ /FOAM GASKET. APPI.Y GASKETTO
,S_E FLAT SURFACEOF GI.ASS.GASKET
Io.iI.OETAli" ENTIREPERIMETER OF GLASS.
cl'*_
_ " <_''k-/l J'/-
" 'k _:Z)\_\
•
T=E-CCWN
___.a CXE7
,, _ LZCAT!ON
_ iV-- -- _ _%.-_ __-- _-_5, _'
/ \ "\
li _ _CTTCM 2F CSCXTC_ :m_--sl
A