Sony STR-DG720 Operating Instructions Manual page 30

Performing Auto Calibration
Measurement for Display
Environment noise NOISE.CHK
level
3
Measurement starts.
The measurement process will take a few
minutes to complete.
The table below shows the display when
measurement starts.
Input
buttons
1/6
switch
VIOJ01 VIDEOZ BO
ovc
8888
SAT TV SA-COICD TUNER
8 - 8 8
TV INPUT TV
I/C!;
SLEEP OMPORT. AV II(!)
0:8
~ ~
2CII A.F.O: MOVIE MUSIC
0 0 0 0
eCDemem OR
OVDlBD
MENU ememecu --
+-+1--
AUTO CAL
O. NING
ecoecueCD
2
1
MUTING
MASTER
VOL +1-
Speaker connection MEASURE and SP
DET. appears
alternately*
Speaker level MEASURE and GAIN
appears alternately*
Speaker distance MEASURE and
DISTANCE appears
alternately *
* The corresponding speaker indicator lights
up in the display during measurement.
4
Measurement ends.
"COMPLETE" appears on the display
and the settings are registered.
1
Press AMP MENU.
2
Press AUTO CAL.
Measurement starts in 5 seconds and the
display changes as follows:
A.CAL [5]
--+
A.CAL [4]
--+
A.CAL [3]
--+
A.CAL [2]
--+
A.CAL [I]
While the time is counting down, stand
away from the measurement area to avoid
measurement error.
When you have finished
Disconnect the optimizer microphone from the
AUTO CAL MIC jack.
Notes
- Auto Calibration cannot detect the sub woofer.
Therefore, all sub woofer settings will be
maintained.
-If you have changed the position of the speakers, it
is recommended that you perform Auto Cal ibration
again in order to enjoy the surround sound.
30 US