Connecting Jumper Cables - Hyundai Entourage 2008 Owner's Manual

What to do in an emergency

Connecting jumper cables

Connect cables in numerical order and
disconnect in reverse order.
Jumper Cables
(-)
(+)
Booster battery
5 4
Jump starting procedure
1. Make sure the booster battery is 12-
2. If the booster battery is in another
3. Turn off all unnecessary electrical
4. Connect the jumper cables in the exact
(-)
(+)
Discharged battery
1VQA4001
volt and that its negative terminal is
grounded.
vehicle, do not allow the vehicles to
touch.
loads.
sequence shown in the illustration.
First connect one end of a jumper
cable to the positive terminal of the
discharged battery (1), then connect
the other end to the positive terminal
on the booster battery (2). Proceed to
connect one end of the other jumper
cable to the negative terminal of the
booster battery (3), then the other end
to a solid, stationary, metallic point (for
example, the engine lifting bracket)
away from the battery (4). Do not con-
nect it to or near any part that moves
when the engine is cranked.
Do not allow the jumper cables to con-
tact anything except the correct battery
terminals or the correct ground. Do not
lean over the battery when making
connections.