Coolant - Yamaha YZF-R15A Owner's Manual

NOTICE: Before installing the
engine oil drain bolt, do not for-
get to install the O-ring, com-
pression spring,
strainer in position.
[ECA10421]
Tightening torques:
Engine oil drain bolt:
32 Nm (3.2 m·kgf, 23.6 ft·lbf)
9. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
Recommended engine oil:
See page 9-1.
Oil quantity:
Without oil filter element replace-
ment:
0.95 L (1.00 US qt, 0.84 Imp.qt)
With oil filter element replacement:
1.00 L (1.06 US qt, 0.88 Imp.qt)
PERIODIC MAINTENANCE AND ADJUSTMENT
NOTICE
●
In order to prevent clutch slip-
page (since the engine oil also
and oil
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a
higher quality than specified. In
addition, do not use oils la-
beled "ENERGY CONSERVING
II" or higher.
● Make sure that no foreign ma-
terial enters the crankcase.
10. Start the engine, and then let it
idle for several minutes while
checking it for oil leakage. If oil is
leaking, immediately turn the en-
gine off and check for the cause.
11. Turn the engine off, and then
check the oil level and correct it if
necessary.
ECA11620

Coolant

The coolant level should be checked
before each ride. In addition, the cool-
ant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
To check the coolant level
1. Place the vehicle on a level sur-
TIP
●
●
2. Check the coolant level in the
7-11
face and hold it in an upright posi-
tion.
The coolant level must
checked on a cold engine since
the level varies with engine tem-
perature.
Make sure that the vehicle is posi-
tioned straight up when checking
the coolant level. A slight tilt to the
side can result in a false reading.
coolant reservoir.
EAU20070
EAU20092
be
7