Setting Security Code; Clearing Security Code - Kenwood KDV-412 Instruction Manual

Menu

Setting security code

Sets a security code to prevent theft.
• To change/reset a security code, the security code is
required. It is recommended that you write down your
security code.
• Before setting a security code, turn off the demonstration
mode. For further information, refer to <Demonstration
setup> (page 54).
1
Set to the menu mode
VOL
AUD
SETUP
Q MENU
MENU
2
Select the security code set feature
3
Start security code setting
ATT
VOL
AUD
SETUP
Q MENU
ENTER
4
Enter a security code
Select the digit to enter.
Select a number to enter.
50 KDV-412
M/S AM
STOP SCAN RDM REP F.SEL M.RDM
SRC
CODE SET
FM
M/S
AM
STOP SCAN RDM REP F.SEL M.RDM
SRC
CODE ––––
:
5
Confirm the entry
ATT
VOL
AUD
SETUP
RE-ENTER
6
Repeat the entry
Using the same method as in the step 4, enter
the same security code.
7
Confirm the entry
PTY/C.S.
SW DISP
ATT
OFF
VOL
AUD
SETUP
APPROVED
8
Exit the security code setting
VOL
AUD
SETUP
SCRL
AME
• If the security code entered in step 6 is different from the
code entered in step 4, you must repeat the procedure
PTY/C.S.
DISP
SW
from step 4.
OFF
• Once the security code has been set, the code needs to
be entered every time the Reset button is pressed or the
battery is disconnected. For further information, refer to
<Security code entry> (page 51).
• The security code can be set in the STANDBY state. For
the basic method of how to operate the menu, refer to
<Menu setup> (page 48).

Clearing security code

Cancels the security code.
1
Set to the menu mode
VOL
AUD
SETUP
MENU
M/S
Q MENU STOP SCAN RDM REP F.SEL M.RDM
CODE ––––
:
M/S
Q MENU STOP SCAN RDM REP F.SEL M.RDM
M/S
Q MENU STOP SCAN RDM REP F.SEL M.RDM
M/S
Q MENU STOP SCAN RDM REP F.SEL M.RDM
FM SCRL
AME
PTY/C.S.
AM SW DISP
SRC
OFF
FM SCRL
AME
PTY/C.S.
DISP
AM SW
SRC
OFF
PTY/C.S.
SW DISP
AM
SRC
OFF
PTY/C.S.
DISP
AM SW
SRC
OFF