Kenwood DV-6050 Instruction Manual page 49

Operation procedure
1.
While the player is in stop mode, press the SET UP
button and press the cursor up/down button to display
the "SOUND" menu of "SET UP MENU".
2.
Press the ENTER button to open the setup screen.
SOUND
Digital Audio
PCM Down Conversion 7 On
Dolby Digital 7 Bitstream
DTS 7 Bitstream
MPEG
7 Bitstream
MENU
Speaker Setting (Custom)
Speaker Setting (Quick)
Audio During Search 7 On
Dynamic Range Control 7 Normal
Audio Filter 7 Filter 60kHz
3.
In the setup menu, select the Function Item (refer to
Right Table) by pressing the cursor up/down button
and press the ENTER button.
4.
Select the Setting Item (refer to Right Table) by
pressing the cursor up/down button, then press the
ENTER button to enter the selection in memory.
¶ "
" : Select to return to the previous screen.
Table : SET UP MENU "SOUND" Function & Setting (2/2)
Function Item
Icon
Audio During
Switches on/off the audio during
Search
search.
÷ Audio is output only in the first
Dynamic Range Switches the dynamic range
EXIT Control control function.
This function compress the
difference between max. and min.
volume, and makes it easier to
listen dialogue at low volume.
Dolby Digital DVD.
Audio Filter Sets the audio filters for protecting
the connected speakers.
Function Icon
On
Off
speed step of fast forward.
Wide
Normal
Midnight
This function only works with
Filter 60 kHz
Filter 110 kHz
Chapter 6: Various Setups
Setting Item
Means
This function is OFF. Set plays the audio at the
level recorded in the disc.
This function works with Low compression
ratio.
This function works with High compression
ratio.
Select when the speakers in use are not suitable
for reproduction of high frequencies.
Select when the speakers in use are suitable for
reproduction of high frequencies.
Initial
Position
On
Normal
Filter 60 kHz
49