Clarke IMAGE 16i Operator's Manual page 15

Pin Earthing Contact
European Plug
Side Earthing Contact
Figure 1
Page 14
240 VOLT MACHINES
INSTRUCTIONS FOR CONNECTION
TO THE POWER SUPPLY
AND THE ELECTRICAL GROUND
CAUTION: This machine will operate only on AC
frequency and electrical voltage
shown on the nameplate. Make sure
you have the correct frequency and
voltage before connecting the power
cord to an outlet.
This product must be grounded. If it should malfunction
or breakdown, grounding provides a path of least resis-
tance for electric current to reduce the risk of electric
shock. This product is equipped with a cord having an
equipment-grounding conductor and grounding plug. The
plug must be inserted into an appropriate outlet that is
properly installed and grounded in accordance with all
local codes and ordinances.
WARNING: Improper connection of the equip-
ment-grounding conductor can re-
sult in a risk of electric shock. Check
with a qualified electrician or ser-
vice person if you are in doubt as to
whether the outlet is properly
grounded. Do not modify the plug
provided with the product - if it will
not fit the outlet, have a proper out-
let installed by a qualified electri-
cian.
This product is for use on a nominal 230 volt circuit and
has a grounding attachment plug that looks like the plug
illustrated in Fig. 1. Make sure that the product is
connected to an outlet having the same configuration as
the plug. No adaptor should be used with this product.
WARNING: To reduce the risk of fire, use only
commercially available floor clean-
ers and waxes intended for machine
application.
This machine is intended for commercial use.
This machine must be connected to the electrical ground
to protect the operator from electrical shock. The machine
has a power cord with two main conductors and one earthing
conductor. Connect the plug to the receptacle. The green
and yellow conductor in the cord is the ground wire. Never
connect this wire to any terminal other than the ground
terminal.
CLARKE TECHNOLOGY Image 16 230V Operator's Manual