AEG Eclipse 15 Quick Start Manual page 8

6.7 Paging
The paging feature enables you to locate a missing handset if the handset is in range and contains
charged batteries.
Press the key under the base unit.
>All the registered handsets that are in range will start to ring.
You can stop the paging by pressing any key on a handset or the
6.8 Switching the Handset On/Off
Press and hold on your Handset for more than 2 seconds to switch the handset on or off in standby
mode.
>When first turned on, the display shows "SEARCHING..." until the handset finds the base.
Note: You can switch the handset off to save battery life, if the handset is not on the base.
IMPORTANT:
When the handset is "OFF", it cannot be used for making calls including emergency calls. It will not ring
when there is an incoming call.
To answer a call, you will need to switch it back on and it may take some time for the handset to re-
establish a radio link with the base unit.
6.9 To Lock/Unlock the Keypad
You can lock the to avoid making calls or pressing the keys accidentally.
In standby mode, press and hold
>The handset displays "KEYS LOCKED".
To turn the keypad lock off, press and hold
Note: Incoming calls can still be answered even if the keypad is locked.
7 PHONEBOOK
The unit can store up to 200 phonebook entries. Each phonebook entry can have a maximum of 24 digits
for the phone number and 12 characters for the name.
7.1 Store a Contact in the Phonebook
From the home screen, press
Press to "PHONEBOOK" and then press
Press to select "NEW ENTRY".
>The screen displays "ENTER NAME".
Enter the name of the contact (maximum 12 characters) using the keypad.
If you make a mistake, press
Press to confirm the name entry.
>The screen displays "ENTER NUMBER".
Enter the number of the contact (maximum 24 digits) using the keypad.
If you make a mistake, press
Press to confirm.
>A confirmation tone is played.
Press to return to standby mode.
Note: You cannot store a new phonebook entry when the memory is full. In this case, you have to delete
existing entries to make space for new ones.
for 2 seconds to lock the keypad.
again.
.
to delete the last character entered.
to delete the last digit entered.
key under the base unit again.
to select.