Becoming Familiar With The Mta Back Panel; Connecting The Mta - Orbitel Digital Phone Getting Started Manual

Installing the InnoMedia MTA 3328-2R

Becoming Familiar with the MTA Back Panel

The back panel of the MTA device contains the input/output ports. Use this
diagram as a reference when setting up your MTA.
► PWR – connects to a wall outlet with the supplied 12-Volt D/C
power adapter.
► RSTR – resets the factory default settings.
► WAN – connects to your broadband Internet connection with an Ethernet
network cable (RJ-45).
► LAN – connects to your PC's Ethernet port with an Ethernet network cable
(RJ-45).
► Phone 2 – connects to an analog telephone with a standard telephone
wire (RJ-11).
► Phone 1 – connects to an analog telephone with a standard telephone
wire (RJ-11).
NOTE: Do not connect your telephone to the Phone 2 port
unless specifically instructed to do so.

Connecting the MTA

These instructions will allow you to connect the MTA directly to your broadband
Internet connection (without an external router). Refer to Figure 2 on the
following page for a diagram of this configuration.
1. Turn off your PC, & unplug the broadband/DSL/cable modem power cord.
IMPORTANT: Do not plug in the MTA's power cord until
instructed to do so.
PWR
WAN
RSTR
Figure 1: The MTA Back Panel
PHONE 2
LAN
PHONE 1
2
(continued)