Breville Quick Touch BMO735 Instruction Booklet page 53

TROUBLESHOOTING
POSSIBLE PROBLEM
Microwave oven
interfering with
television reception.
Dim microwave
oven light.
Steam accumulating
on door and hot air
coming out from vents.
POSSIBLE PROBLEM
Microwave oven will
not start.
Microwave oven
does not heat.
Glass turntable makes
noise during operation.
LCD time digit shows
EA1A then V1:00 or
similar information
then goes to default
mode.
LCD time digit shows
00 for a short period
of time then shows 1 or
0 and stays at 1 or 0.
EASY SOLUTION
• Radio and TV reception may be interfered with during
operation. This is similar to the interference that is sometimes
cause by vacuums, blenders etc.
• When operating on low power levels, the microwave oven light
may be dimmer.
• During operation, steam may be produced. Most will exit
through the vents, however some may accumulate around the
oven door.
POSSIBLE REASON
• Power cord not
plugged in properly or
switched on.
• Fuse blown or circuit
breaker problem.
• Trouble with outlet.
• Door not closed
properly.
• Turntable roller not
assembled properly or
needs to be cleaned.
• Both STOP/Clear &
SMART COOK button
are pressed at the same
time under the default
mode.
• Both STOP/Clear &
SMART REHEAT
button are pressed at
the same time under
the default mode.
EASY SOLUTION
• Unplug, put the plug in again
and switch on.
• Replace the fuse or reset circuit
breaker.
• Have a professional check that
the outlet is not faulty.
• Ensure door is shut properly.
• Reset and clean if necessary.
• No action required. This is
normal and LCD just shows
the model type and software
version.
• If the LCD time digit stays at 0,
send the unit back to repair.
• 0 indicates Sensor IQ
transducer is not OK.
• If LCD time digit stays at 1,
Press STOP/Clear to set the
unit back to default mode.
• 1 indicates Sensor IQ
transducer is OK.
53