Panasonic TH-98LQ70U Operating Instructions Manual page 60

Serial ID function
Set to control external control with the PC connected to
SERIAL terminal according to the Display's ID number
(Panel ID).
[Off]: Disables external control by the ID.
[On]: Enables the external control by the ID.
LAN control protocol
Select the LAN control protocol.
[Protocol 1]: Control with the Panasonic Display
sequence.
[Protocol 2]: Control with the sequence that
compatible with Panasonic Projector.
Note
●
When using "Early Warning Software" (see page 66),
set to [Protocol 2].
RS-232C/LAN information timing
Set up the informing manner for no signal or
temperature rising.
During RS-232C controls:
Warning or error message sent on the display
automatically.
During LAN controls:
Acquire the warning or error message from the
display.
1
Select the item with
Select the set point with
RS-232C/LAN information timing
No signal warning
No signal warning timing
No signal error
No signal error timing
Temperature warning
[No signal warning]
When set to [On], the display sends out the no signal
warning.
[No signal warning timing]
Set up the detecting time for no signal warning.
(Range: 01 - 60, Interval: 1 minute)
[No signal error]
When set to [On], the display sends out the no signal
error.
60
English
.
.
On
5min
On
10min
On
[No signal error timing]
Set up the detecting time for no signal error.
(Range: 01 - 90, Interval: 1 minute)
● The warning of [No signal warning] and the error of
[No signal error] are not sent when the no signal state
is detected through any of the following functions:
[No signal power off], [PC power management],
[DVI-D power management], [HDMI1 power
management] - [HDMI4 power management] (see
page 46)
●
If there is no signal when [PC IN] is input, [PC power
management] is activated first and the Display enters
the standby mode.
Setting Example:
[No signal warning timing]: 5 minutes
[No signal error timing]: 10 minutes
[PC power management]: [On] (60 seconds)
Note
●
The [No signal error timing] cannot be set shorter
than [No signal warning timing].
[Temperature warning]
When set to [On], the display sends out the
warning temperature.