Label - Sony Ericsson D750i Working Instructions

4 Label

TOOLS
•
Hot air flow solder station
•
Blunt pair of tweezers
•
Zebra printer and computer
INSTRUCTION
This instruction should be used when exchanging an old
label or assembling a new one.
Note the position of the label before removal!
One label only is allowed on the frame!
1. Read the old label and/or write the information into the
"Labelmake" program.
2. Heat up the label with a hot air flow solder station, if
needed.
3. Carefully remove the label and make sure that all
residues are gone.
If necessary, clean the surface with isopropyl alcohol.
Do not scratch the frame.
4. Check that the right label format is loaded in the Zebra
printer.
5. Write a new label by using the program "Labelmake".
Check that the printing is ok.
6. Take the new label and place it onto the frame as in
the picture.
Make sure the label is placed in its proper position.
3/00021-1/FEA 209 544/95 G
©
Company Internal Sony Ericsson Mobile Communications AB
D750i, K758c, W800 and W700 Working Instructions - Mechanical
42(43)