Panasonic CF-53 Series Operating Instructions Manual page 27

„ Starting Up
Windows startup and opera-
tion is slow.
The date and time are incor-
rect.
[Executing Battery Recali-
bration] screen appears.
[Enter Password] does not
appear when resuming from
sleep/hibernation.
Cannot resume.
F9 in the Setup Utility (è
l Press
Setup Utility settings (excluding the passwords) to the default values. Start the Setup
Utility and make the settings again. (Note that the processing speed depends on the ap-
plication software, so this procedure may not make Windows faster.)
l If you installed a resident software after purchase, turn off the residence.
l Make the correct settings.
A Open the Control Panel.
1. Right-click any empty location on the Start screen.
2. Click [All apps] on the app bar.
3. Click [Control Panel] under "Windows System".
Click (Start) - [Control Panel].
B Click [Clock, Language, and Region] - [Date and Time].
l If the problem persists, the internal clock battery may need to be replaced. Contact
Panasonic Technical Support (è pages 37 - 41).
l When the computer is connected to LAN, check the date and time of the server.
l The 2100 A.D. or later year will not be correctly recognized on this computer.
l The Battery Recalibration was cancelled before Windows was shut down last time. To
start up Windows, turn off the computer by the power switch, and then turn on.
l Select [Enabled] in [Password On Resume] in the [Security] menu of the Setup Utility
(è Reference Manual "Setup Utility").
l The Windows password can be used instead of the password set in the Setup Utility.
A Open the Control Panel.
1. Right-click any empty location on the Start screen.
2. Click [All apps] on the app bar.
3. Click [Control Panel] under "Windows System".
Click (Start) - [Control Panel].
B Click [User Accounts and Family Safety] - [Add or remove user accounts].
C Click [System and Security] - [Power Option] - [Require a password when the com-
puter wakes] and add a check mark for [Require a password].
l One of the following operations may have been carried out. Press the power switch turn
on the computer. Data not saved will be lost.
Ÿ In sleep mode, the AC adaptor or battery pack was disconnected, or a peripheral was
connected or disconnected.
Ÿ The power switch was slid for four seconds or longer to forcibly turn off the computer.
l An error may occur when the computer automatically enters the sleep or hibernation
mode while the screensaver is active. In this case, turn off the screensaver or change
the pattern of the screensaver.
Reference Manual "Setup Utility") to return the
27