Digital Clock Functions; How To Set Correct Time - S.E.M. Ergo IP-10 User Manual

DIGITAL CLOCK
DIGITAL CLOCK FUNCTION
- The set has a built-in digital clock, which is displayed in 2 situations:
(1) When the set is in "Standby mode". (The display will continuously show the current
time). In this situation the blue backlight is normally off (to save electricity) but you
can switch on the blue display light by pressing any key, (on the set or remote control)
except the "On/ Standby" key. This will activate the blue light for approximately 5
seconds.
(2) When the set is in "on mode" (the blue light of the display is "on" in this mode, to
indicate that the set is powered "on"). In this situation the LCD display normally does
not automatically show the current time. But you can press & hold the "EQ/DISPLAY/
CLOCK ADJ." key for 2 seconds at any time to see the current time. Each time you
press & hold the "EQ/DISPLAY/CLOCK ADJ." key for 2 seconds the current time will
be displayed on the LCD screen for 5 seconds.

HOW TO SET CORRECT TIME:

Switch unit to "Stand-by" mode (Display light = off)
Press & hold EQ/DISPLAY/CLOCK ADJ. or CLOCK ADJ. key
Press NEXT or BACK to select 12-hour or 24-hour clock display system &
press EQ/DISPLAY/CLOCK ADJ. or CLOCK ADJ. key (on remote control)
Press NEXT or BACK repeatedly to set the correct Hour in the display &
press EQ/DISPLAY/CLOCK ADJ. or CLOCK ADJ. key
Press NEXT or BACK repeatedly to set the correct Minute in the display &
press EQ/DISPLAY/CLOCK ADJ. or CLOCK ADJ. key
Correct time is now set & will be shown in the display.
(on remote control) for 3 seconds display
shows hour or
12
to confi rm your selection
(on remote control) to confi rm
(on remote control) to confi rm
E-6
hour (fl ashing)
24