Operation Of Radio; Manual Frequency Adjustment; Automatic Frequency Adjustment; Radio Memory - S.E.M. Ergo IP-10 User Manual

RADIO

OPERATION OF RADIO

- Press the "On/ Standby" key once to switch on the unit.
- Press the FUNCTION key repeatedly until the display shows "tuner".
- Extend and adjust the fm-wire antenna to obtain the best reception.
- Use the STEREO/MONO key (on remote control) to select the desired mode. In some
cases, where reception is poor, it may be advisable to select "mono" mode, to improve
clarity of the radio signal.
MANUAL FREQUENCY ADJUSTMENT (SCAN MODE)
- Press (and immediately release) the TUNE + and TUNE - keys to "scan" (manually
adjust) the radio frequency "up" or "down" by 1-step at a time.
- The radio digital display will indicate the exact frequency at each step's position.
- When a desired frequency or station is reached. It can be saved into one of the "memory"
positions. (See "radio memory" section).
AUTOMATIC FREQUENCY ADJUSTMENT (SEEK MODE)
- Press and hold (for 2 seconds) the TUNE + and TUNE - keys to "seek" (automatically
adjust) the radio frequency "up" or "down" to the next available radio station.
- The radio digital display will indicate the exact frequency of the next station that is found.
- When a desired station is reached. It can be saved into one of the "memory" positions.
(See "radio memory" section).
RADIO MEMORY (STATION PRESET MEMORY STORAGE
- At any time, the currently displayed station or frequency can be stored into one of the
memory positions.
- Press STOP/MEMORY key until "01" fl ashes in the display.
- Press MEN + or MEN - to select desired memory position. (There are total 20 memory
positions).
- Press STOP/MEMORY key once to save the selected station into the selected memory
position.
- To recall any saved memory, simply press MEN + or MEN - , the saved radio-band
will be recalled.
- To clear the memory of any position, simply save a new station to the same memory
position.
E-11