Hitachi DH 25PA Handling Instructions Manual page 15

Outer diameter
11.0 mm
12.3 mm
12.7 mm
14.3 mm
14.5 mm
17.5 mm
21.5 mm
13 mm Hammer drill chuck
For drilling operations when using a straight shank bit for impact drilling with a hammer drill.
Straight shank bit
(
for impact drill
2. Anchor setting (Rotation + Striking)
Anchor setting adapter (for an electric hammer drill)
Anchor setting adapter (SDS-plus shank)
(for electric hammer drill)
Overall length: 160, 260 mm
Anchor setting adapter (for a manual hammer)
3. Large hole boring (Rotation + Striking)
Center pin, core bit, core bit shank and guide plate.
(Guide plate) Center pin
Taper mode
Morse taper (No.1)
Morse taper (No.2)
A-taper
B-taper
13 mm Hammer drill chuck
)
(SDS-plus shank)
Chuck wrench
Anchor size
W1/4"
W5/16"
W3/8"
W1/2"
Anchor size
W1/4"
W5/16"
W3/8"
W1/2"
W5/8"
Core bit
Applicable drill bit
Drill bit (taper shank)
Drill bit (taper shank)
Taper shank adapter formed A-taper or B-taper
is provided as an optional accessory, but the
drill bits for them are not provided.
Anchor setting adapter
(for a manual Hammer)
Core bit shank
(SDS-plus shank)
11.0 – 17.5 mm
21.5 mm
14