Kenwood KDC-MP6090R Instruction Manual page 46

Cd receiver
Hide thumbs Also See for KDC-MP6090R:
Table of Contents

Advertisement

Troubleshooting Guide
CD/MP3/External disc control mode
PROBLEM
The disc control mode cannot
be selected.
The specified disc does not
play, but another one plays
instead.
The sound skips.
The display shows that the
changer is being played, but no
sound can be heard.
The specified track does not
play.
Track repeat, disc repeat, track
scan, random play, and
magazine random play start by
themselves.
Cannot play CD-R or CD-RW
If the following situations, consult your nearest service centre:
• Even though the disc changer is connected, the Disc Changer Mode is not on, with "AUX" showing in the display during the Changer Mode.
• Even though no device (KCA-S210A, CA-C1AX, KDC-CPS87, KDC-CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected, the AUX Mode is
entered when switching modes.
POSSIBLE CAUSE
No cable has been connected to the disc changer input
terminal on the unit.
The specified CD is very dirty.
The CD is upside-down.
The disc is loaded in a different slot from that specified.
The disc is severely scratched.
Something is touching the disc changer.
The CD is scratched or dirty.
The computer chip in the unit is not functioning normally.
Random play or magazine random play has been
selected.
The setting is not cancelled.
Finalization processing is not being conducted for CD-
R/CD-RW.
A non-compatible CD changer is being used to play the
CD-R/CD-RW.
Connect the cable to the disc changer input terminal on
the unit.
Clean the CD.
Load the CD with the labelled side up.
Eject the disc magazine and check the number for the
specified disc.
Try another disc instead.
Remove whatever is touching it.
If skipping happens at the same place when the car is
stopped, something is wrong with the CD. Clean the CD.
Press the reset button on the unit (see page 4).
Turn off the random play or magazine random play
function.
The settings for these functions remain on until the
setting to off or the disc ejected, even if the power is
turned off or the source changed.
Conduct finalization processing with CD recorder.
Use a CD changer compatible with CD-R/CD-RW to play.
— 46 —
SOLUTION

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents