AMSTRAD CPC464 User Manual page 15

Press down the key marked [CTRL] (Control), and AT THE SAME TIME press the small [ENTER]
key at the bottom right of the number-only keypad next to the Datacorder. The screen will respond
with the instructions:
R U N "
P r e s s P L A Y t h e n a n y k e y :
Now press the [PLAY] key in the row at the front of the Datacorder until it locks down firmly,
followed by pressing any letter, number, or either [ENTER] key - or the space bar.
The tape will start to move, and after a short time you will see this message appear on the screen:
Lo a d i n g W E L C O M E b l o c k 1
The tape will take approximately 5 minutes to load, you can see this happening on the screen since
' block' number will change to 2,3 etc., until the tape stops. At this time the ' Welcome' program will
begin to run. Just sit back and watch. The program runs continuously, so when you have finished
watching press the [ESC] key twice. This stops the program and you can now [STOP] and eject the
cassette, then turn it over to run side two.
After turning the cassette over ready for Side 2, once again remember to press the [REW]ind button
on the datacorder to ensure that the tape is rewound to the start.
Press down the key marked [CTRL] (Control), and AT THE SAME TIME press the small [ENTER]
key at the bottom right of the number-only keypad next to the Datacorder. The screen will respond
with the instructions:
R U N "
P r e s s P L A Y t h e n a n y k e y :
Now press the [PLAY] key in the row at the front of the Datacorder until it locks down firmly,
followed by pressing any letter, number, or either [ENTER] key - or the space bar.
The tape will start to move, and after a short time you will see this message appear on the screen:
L o a d i n g W E L C O M E 2 b l o c k
1
Follow the instructions given on the screen, and the program will invite you to participate by typing
instructions as it progresses.