Other Features; Audio Control Setting; Clock Display; Adjusting Time - Kenwood KDC-4060RA Instruction Manual

Other features

(See page 8)

Audio Control Setting

Adjust various parameters of sound quality.
1
Press the AUD button to enter the control mode.
Each time the AUD button is pressed, the adjustment mode
display changes as follows:
7 Bass 7 Treble 7 Balance 7 Fader 7 Volume
If you do not move to step 2 in 5 seconds, the unit will switch
back to the volume adjustment mode (i.e., the normal mode).
NOTE
Source tone memory
Each source (CD, FM, and AM) has its own memory in which to
store the bass and treble tone settings.
The settings made for a particular source are then recalled
automatically whenever you use that source (e.g., FM mode uses
the tone settings made for FM, AM for AM, etc.).
2
Press the d/u buttons to adjust the mode shown in the
display.
Use the following table as a guide for adjusting the settings in
each mode.
Adjustment
Operation of Audio control button
mode
d button
(Display)
Bass
Bass decreased.
("BAS")
Treble
Treble decreased.
("TRE")
Balance Left channel
("BAL") emphasized.
Fader Rear channel
("FAD") increased.
Display the time.
Switching to Time Display:
When the RDS station tuned into is transmitting a time signal,
have the unit's built-in time adjust automatically to the
correct local time.
Adjusting the Time:
u button
Bass increased.
Treble increased.
Right channel
emphasized.
Front channel
increased.
— 20 —

Clock Display

Press the CLK button repeatedly until the clock is displayed.

Adjusting Time

Tune into an RDS station for 3 or 4 minutes.
The time adjusts automatically to the correct local time.
NOTE
• The displayed time cannot be set manually, but only through
RDS station time signals.
• The time is not adjusted when the RDS station you are tuned to
is not transmitting a time signal. Choose another RDS station in
such a case.