G-Analyzer Reset; G-Counter Level Setting; G-Analyzer Calibration Setup - Kenwood eXcelon KDC-X991 Instruction Manual

General features
Display Type E

G-Analyzer Reset

Resets the value of G-Meter, G-Counter and G-
Analyzer Horsepower Analysis.
1
Enter G-Analyzer Reset mode
Using the Control knob, select "DISPLAY" >
"GMA" > "RESET".
For the operation method, refer to <Function
Control mode> (page 11).
"G-RESET" is displayed.
2
Select the Reset item
Turn the Control knob.
Display Setting
"Meter Reset" Reset the value of G-Meter.
"Power Reset" Reset the value of G-Analyzer Horsepower
Analysis.
"Counter Reset" Reset the value of G-Counter.
3
Determine the item you want to reset
Press the Control knob.
4
Reset the value
Select "YES" using the Control knob.
"Reset OK" is displayed.
5
Exit G-Analyzer Reset mode
Press the [FNC] button.
Display Type E

G-Counter Level setting

Calibrating G-Point. Setting the level according to
the kinds of vehicles.
1
Enter G-Counter Level setting mode
Using the Control knob, select "DISPLAY" >
"GMA" > "LEVEL".
For the operation method, refer to <Function
Control mode> (page 11).
"G-COUNTER LEVEL" is displayed.
2
Select the G-Counter Level
Turn the Control knob.
Display Setting
"Level 1" Counter is easy to go up.
"Level 2"
"Level 3" Counter is hard to go up.
22
|
English
3
Exit G-Counter Level setting mode
Press the Control knob.
⁄
• In the case of driving situations calling for few
accelerations, set the G-Point up to "Level 1". In the case
of frequent accelerations, set it up to "Level 3".
In Standby mode
Display Type E

G-Analyzer Calibration setup

G-Analyzer requires calibration for horizontal
acceleration and braking.
⁄
• To ensure accurate calibration, go through the following
steps at a level place where you can move the vehicle
straight ahead.
1
Park the vehicle in a horizontal location
2
Enter G-Analyzer Calibration setup mode
Using the Control knob, select "DISPLAY" >
"GMA" > "CALIB".
For the operation method, refer to <Function
Control mode> (page 11).
"G-CALIBRATION" is displayed.
3
Start Calibration of horizontal direction
Press the Control knob.
Once "Move Forward" appears on the display, the
vehicle must be advanced.
4
Start Calibration of straight direction
Start moving the vehicle ahead.
Calibration of straight direction automatically starts.
When the Calibration is finished, "Calibration OK" is
displayed.
⁄
• If you fail to complete the calibration, "No Calibration" is
displayed. In such a case, repeat steps 1 through 4.
5
Exit G-Analyzer Calibration setup mode
Press the [FNC] button.