Listening To Cassette Tapes; Preparation; Normal Playback - Kenwood KXF-W1030 Instruction Manual

Listening to cassette tapes

10

Preparation

1 Set the POWER switch to ON.
POWER
- ON – OFF

Normal playback

1
Determine the playback conditions.
1 Select the Dolby NR mode.
(dB) — —5 0 +3 +6 (dB)
2 Select the playback mode.
(CT-403/KXF-W3030 only)
(dB) — —5 0 +3 +6 (dB)
2
Start playback.
CT-403
/KXF-W3030
@ 7 #
2 Load a cassette tape in deck A or B. (Normal playback)
Load cassette tapes in both decks. (Relay playback)
Press the area marked
PUSH/OPEN 0.
÷ Be sure to remove tape slack before insertion.
÷ The type of tape, that is, the Normal, High position or
Metal position (playback only) is selected automatically.
÷ This unit cannot record sound on a Metal tape.
DOLBY NR
REV.MODE
CT-401
/KXF-W1030
or
3
The figure shows an example for the CT-403 or KXF-W3030
PUSH/OPEN
0
POWER
1 ¡
A
TAPE
AUTO REVERSE
@ 7 #
: Keys or controls to be used in this operation
÷ Set to OFF the Dolby NR key when playing a tape recorded with-
out using Dolby NR.
1 Dolby NR on
2 Dolby NR off
÷ Each press switches the indication.
1 "[" :Double-side playback which stops tape after having
played both sides.
2 """ :Playback is endless.
3 """ :One-way playback which stops tape after having played
a single side.
÷ Tapes are played in the directions indicated by their
respective indicators. (CT-403/KXF-W3030)
÷ Playback stops automatically at the end of tape.
(CT-401/KXF-W1030)
PUSH/OPEN
0
(dB) — —5 0 +3 +6 (dB)
1 ¡ 8 ¶
PAUSE REC/ARM
B
TAPE
AUTO REVERSE
@ 7 #
÷ Be sure to close the cassette
holder securely by pushing it.
Dolby NR off
Dolby NR on
DOLBY NR DOLBY NR
Goes off
Lit