Accessory Connections; Front Panel; Headphones (Phones); Microphone (Mic) - Kenwood TS-570D, TS-570S Instruction Manual

ACCESSORY CONNECTIONS

FRONT PANEL

Headphones (PHONES)

Use headphones having 4 to 32
can also use stereo headphones. When
headphones are used, no sound is heard from the
internal (or optional external) speaker. Use a 6.0 mm
(1/4") diameter, 2-conductor (mono) or 3-conductor
(stereo) plug.

Microphone (MIC)

To communicate in the voice modes, connect to the
MIC connector a microphone having an impedance
between 250 and 600 . Insert the connector
from your microphone fully, then screw the retaining
ring clockwise until snug. Compatible microphones
include the MC-43S, MC-47, MC-60A, MC-80,
MC-85, and MC-90. Do not use the MC-44,
MC-44DM, MC-45, MC-45E, MC-45DM,
MC-45DME, MC-52DM, or MC-53DM microphone.

REAR PANEL

External Speaker (EXT SP)

Ensure any external speaker used has an
impedance of 8 . Use a 3.5 mm (1/8") diameter,
2-conductor (mono) plug. When an external speaker
is used, no sound is heard from the internal speaker.
WARNING! DO NOT CONNECT HEADPHONES TO THIS
JACK. THE HIGH AUDIO OUTPUT AT THIS JACK COULD
DAMAGE YOUR HEARING.
Keys and Keyboards for CW Operation
(PADDLE and KEY)
For CW operation using the internal electronic keyer,
connect a keyer paddle to the PADDLE jack. For
CW operation without using the internal electronic
keyer, connect a straight key, semi-automatic key
(bug), electronic keyer, or the CW keyed output from
a Multimode Communications Processor (MCP) to
the KEY jack. The jacks mate with a 6.0 mm (1/4")
3-conductor plug and a 3.5 mm (1/8") 2-conductor
plug respectively. External electronic keyers or
MCPs must use positive keying to be compatible
with this transceiver. Use a shielded cable between
the key and the transceiver.
Note: Due to the full-featured functionality of the internal
electronic keyer, you may decide it's unnecessary to connect
both a paddle and another type of key unless you specifically
want to use a keyboard for CW. It's recommended that you
become familiar with the internal keyer by reading
"ELECTRONIC KEYER" {page 34} before making your decision.
impedance. You
•
•
•
•
Headphones
TS-570
MICq
PTTw
DOWNe
UPr
Microphone
MIC connector (Front view)
External speaker
TS-570
Ground +
Ground Dash Dot
Straight key
Bug
Electronic keyer
MCP CW output
1 INSTALLATION
iGND(STBY)
uGND(MIC)
yNC
t8 V(10 mA max)
• Paddle
3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16