Split-Frequency Channels; Memory Recall And Scroll; Memory Recall - Kenwood TS-570D, TS-570S Instruction Manual

10 MEMORY FEATURES

Split-Frequency Channels

1
1 Press [A/B] to select VFO A or VFO B.
• "tA" or "tB" appears to show which VFO is
selected.
2
2 Select the frequency, mode, etc. to be stored.
• The frequency and mode selected here will be
used for transmitting.
3
3 Press [A/B] to select the other VFO.
4 Select the receive frequency and mode.
5 Press [SPLIT].
4
• "SPLIT" appears.
5
6
6 Press [M.IN] to enter Memory Scroll mode.
7
8
• To exit Memory Scroll mode and abort the
storage process, press [CLR].
9
7 Turn the MULTI/CH control, or press Mic [UP] or
[DWN] to select a memory channel.
• Entering a 2-digit number such as 05 using
10
the numeric keys can also be used to select a
channel.
11
12
8 Press [M.IN] again to store the data.
13
• The previous data stored in the channel is
overwritten.
Note: When subtone frequencies differ between TX and RX
while performing memory-VFO split operation, the subtone
frequency for RX will be stored in the memory channel.
14
15
16
40

MEMORY RECALL AND SCROLL

There are two modes that allow you to retrieve
frequencies and associated data that you stored in a
memory channel: Memory Recall and Memory Scroll.

Memory Recall:

In this mode, the transceiver receives and transmits
using a frequency that you retrieve. You can
temporarily change the frequency and associated data
without overwriting the contents of the memory channel.
Memory Scroll:
Use this mode to check the contents of memory
channels without changing the current receive
frequency. In this mode, frequencies that you retrieve
are not used for receiving and transmitting.
Memory Recall
1 Press [M/V] to enter Memory Recall mode.
• The memory channel that was last selected
appears.
2 Turn the MULTI/CH control, or press Mic [UP] or
[DWN] to select a memory channel.
• Continuously holding down Mic [UP] or
[DWN] steps the transceiver through the
memory channels until the button is released.
• The memory channels that contain no data
are skipped.
• You cannot change memory channels while
transmitting.
3 To exit Memory Recall mode, press [M/V].
Note: Memory channels can also be changed while using the
TF-SET function.