REDROTOR RC STRIDER 250 Assembly Manual page 3


Center Plate with onboard RROSD engine (x1)

Bottom Plate (x1)

Top Plate (x1)

Arms (x4)

HD Plate (x1)

CCD Board Camera mount (x1)

Aluminum M3 x 6mm (x10) (top plate)

Aluminum M3 x 8mm (x4) (arm pivot)

Aluminum M3 x 10mm (x4) (arm slot)

Aluminum M3 x 16mm (x10) (lower plates)

Nylon M3 x 3mm Spacer (x14) (lower plates)

Nylon M3 x 12mm (x4) (flight controller)

Nylon M3 hex nut (x4) (flight controller)

Nylon 35mm F/F Standoff (x10) (center frame)

Nylon 10mm M/F Standoff (x4) (flight controller)

Nylon M3 washer (x4) (arm pivot)

Rubber Soft Bobbin (x3) (HD plate)

Captive nut (x8) (RROSD plate)

M3 Nylon locking nut (x4) (arm slot)
*Don't be alarm if you see extra hardware, those are included as spares
If you find anything missing please contact your retailer or email

M3 Allen/hex key/driver *size #2

M3 Hex socket driver

Soldering Iron with a thick tip

60/40 Rosin core solder or varying thickness

Shrink Tubing of various diameters

(Optional but recommended) Zip ties of varying sizes

(Optional but recommended) Battery Strap (Scorpion or other branded Straps)

(Optional but recommended) Wire Mesh Braid or Paracord
SUPPORT@REDROTOR.COM immediately.