Advertisement
Run "RRLoader.exe" (icon created on your desktop)
As a safety caution, remove all props first, and connect power to the Strider
Choose the correct COM number, and click "Load"
Remove power and disconnect programmer from RROSD when firmware loading is finished
Power up Strider and the OSD version listed on initial boot-up on the on screen display should be
updated if everything worked correctly
To switch between video modes hold down on the button on the right edge of the RROSD board. Keep
depressed while power up the board. Keep the button depressed for around 10 seconds until the LEDs turn
on. Release the button and unplug the battery, you have now switched modes
The RROSD LEDS, buzzer, crosshair, timer start/stop, and Lost Model Mode are all controlled via a 3
position switch. The switch should be set to center before plugging in
Each flip of the switch to the high position will:
Start the Timer (if it's stopped)
Pause the timer (if it's running)
Deactivate the crosshair
Each flip of the switch back to center will:
Reactivate the crosshair
Each flip of the switch to the low position will:
Cycle through 3 modes: Activate LEDs full on Activate Lost Model Mode (strobe lights and
buzzer) LEDS and buzzer deactivated
To enter into the menu of the RROSD, power up the board and hold down on the button on the right edge
of the RROSD board within 3 seconds of powering up. Keep it depressed until the menu appears in your
view then release
Advertisement
