Sky Command 2 2 2 2 - Kenwood TM-D700 E Instruction Manual

The Sky Command 2 allows remote control of a
TS-570D, TS-570S, or TS-870S HF transceiver. Besides
the HF transceiver, this system requires two transceivers
capable of working the Sky Command 2. This
transceiver and TH-D7A handhelds are currently
available. You will use one transceiver as a control
station called "Commander". The transceiver connected
with the HF transceiver is called "Transporter". It will
function as an interface between the Commander and
the HF transceiver. This system allows you, for
example, to watch for and hunt DX while washing your
car, or to operate the HF transceiver while relaxing in
your car, living room, or patio, instead of in your shack.
HF freq.
17
76
SKY COMMAND 2 2 2 2 2 (U.S.A./ CANADA ONLY)
Your shack
The Commander and Transporter transfer audio and
commands as below:
VHF freq.
Audio
UHF freq.
Audios
Control commands
tResponse
Commander Transporter
Audio
PF POWER
HF TRANSCEIVER TS-570D N.R.
ATT PRE-AMP B.C.
VOX PROC CW TUNE
SEND AT TUNE FILTER
CH1 CH2 CH3 DOWN UP RIT/XIT
PHONES MIC LSB MR
1 2 3 USB
ANT REC FINE M.IN – +
4 5 6 PWR FSK CW
SPLIT TF-SET A/B RIT
MIC NB AGC/TONE REV KEY CH IF SHIFT
7 8 9 FM
AM M/V A=B CLEAR XIT
Control commands F.LOCK DELAY MENU 1MHz
CLR 0 ENT
SCAN M>VFO M.IN
tResponse
DSP SLOPE HIGH LOW
AF RF
4 6
2 8
0 10
SQL
4 6
2 8
0 10