Table of Contents
Advertisement
III. INSTALLATION
Jumpers
1. Flash ROM Boot Block Programming (BBLKW)
This sets the operation mode of the boot block area of the Programmable Flash
ROM to allow programming in the Enabled position. This is required only if
prompted by the Flash Memory Writer Utility as shown in BIOS SOFTWARE.
2. Real Time Clock (RTC) RAM
This clears the user-entered information stored in the CMOS RAM of the Real
Time Clock such as hard disk information and passwords. To clear the RTC
data: (1) Turn off the PC, (2) Short this jumper, (3) Power on the PC, (4) Turn
off the PC, (5) Remove this jumper, (6) Power on the PC, (7) Hold down
<Delete> during bootup and enter BIOS setup to re-enter user preferences.
3. Voltage Regulator Output Selection (VID0, VID1, VID2)
Intel P55C Pentium
Intel P54C Pentium
(75-200MHz)
MMX (200MHz)
BBLKW
1
2
3
Disabled / Protected
(Default)
Boot Block Programming (Disable / Enable)
Operation (Default)
RTC RAM (Operation / Clear Data)
AMD-K5
(PR75-133MHz)
3 2 1
3 2 1
3 2 1
VID2
VID1
VID0
2.5V
2.7V
2.8V
AMD3
AMD1
P55C
Voltage Regulator Output Selection
VX97 User's Manual
BBLKW
1
2
3
Enabled
Clear Data
Cyrix 6x86 166+
Rev2.7 (133MHz)
3 2 1
3 2 1
3 2 1
2.9V
3.4V
3.5V
AMD2
STD
VRE
7
Advertisement
Table of Contents
