Asus VX97 User Manual page 11

III. INSTALLATION
6. Power connector (12-pin block)
This connector connects to a standard 5 Volt power supply. To connect the leads
from the power supply, ensure first that the power supply is not plugged. Most
power supplies provide two plugs (P8 and P9), each containing six wires, two of
which are black. Orient the connectors so that the black wires are located in the
middle.
Power Connector
Using a slight angle, align the plastic guide pins on the lead to their receptacles
on the connector. Once aligned, press the lead onto the connector until the lead
locks into place.
7. IrDA-compliant infrared module connector (IR)
This connector supports the optional wireless transmitting and receiving infra-
red module. This module mounts to a small opening on system cases that sup-
port this feature. You must also configure the setting through "UART2 Use
Infrared" in Chipset Features Setup of the BIOS SOFTWARE to select whether
UART2 is directed for use with COM2 or IrDA. Use the five pins as shown on
the Back View and connect a ribbon cable from the module to the motherboard
according to the pin definitions.
Infrared Module Connector
+5V
PG +12V GND
+5V -12V
-5V
AT Power Connector
on Motherboard
Front View
+5V
NC
IRRX
GND
IRTX
For the infrared feature to be available,
you must connect an optional Infrared
module to the motherboard.
VX97 User's Manual
P9
P8
Power Plugs from
Power Supply
Back View
+5V
IRTX
NC
GND
IRRX
11