Asus VX97 User Manual page 12

7. Primary / Secondary IDE connectors (Two 40-pin Block)
These connectors support the provided IDE hard disk ribbon cable.
After connecting the single end to the board, connect the two plugs at the other
end to your hard disk(s). If you install two hard disks, you must configure the
second drive to Slave mode by setting its jumper accordingly. Please refer to the
documentation of your hard disk for the jumper settings. BIOS now supports
SCSI device or IDE CD-ROM bootup (see "HDD Sequence SCSI/IDE First" &
"Boot Sequence" in the BIOS Features Setup of the BIOS SOFTWARE).
TIP: You may configure two hard disks to be both Masters using one ribbon
cable on the primary IDE connector and another ribbon cable on the secondary
IDE connector. You may install one operating system on an IDE drive and
another on a SCSI drive and select the boot disk through BIOS Features Setup.
IDE (Hard Drive) Connectors
8. IDE activity LED (IDE LED)
This connector supplies power to the cabinet's IDE activity LED. Read and
write activity by devices connected to the Primary or Secondary IDE connectors
will cause the LED to light up.
Hard Drive LED Lead
12
III. INSTALLATION
Primary IDE Connector
TIP: If the case-mounted LED does not light,
try reversing the 2-Pin plug.
IDE (Hard Drive) LED
VX97 User's Manual
Pin 1
Connect the Red stripe to Pin 1
Secondary IDE Connector