Honeywell 16100 Series Owner's Manual page 5

Step 1: Turn the Air Cleaner OFF (
Step 2: To open back grille, place your fingers on the two tab indentations
at the top of the unit just behind the calendar wheel window area and gently
push down and release the grille (Fig. 1). Completely remove back grille
from unit.
Step 3: Remove HEPA and Odor-Lock™ filter assembly from the unit.
Step 4: Remove the Odor-Lock™ filter from the HEPA filter (Fig. 2).
Step 5: Replace the filter(s) as needed, and discard used filter(s).
Step 6: Attach the Odor-Lock™ filter to the HEPA filter using the fasteners that are pre-
attached to the HEPA filter.
NOTE: When placing the filter assembly back in the unit, make sure that the
surface of the HEPA filter that contains the foam sealant material is against
the plastic divide (Fig. 3, Fig. 4).
Step 7: Before reattaching the back air cleaner grille, set appropriate filter change
calendar(s) ahead according to the schedule provided (Fig. 4).
Step 8: To reattach the back air cleaner grille, insert the tabs on the bottom of the
back grille into slots on the bottom of the unit base. Next, insert the side tabs on
the back grille with the slots on the side of the unit. Then, push down firmly on
top tabs, insert and lock in place.
Step 9: Plug into a wall outlet.
Filter Replacement Reminders
Filter change schedule (depending upon use and conditions):
– Odor-Lock™ filter: Replace every 3-6 months depending on use
– HEPA filter: Replace every 1-3 years depending on use
Upon start up of your Air Cleaner and every Odor-Lock™ filter replacement, roll the
Monthly Filter Change Calendar ahead 3-6 months to indicate when filter replacement is
necessary.
Upon start up of your Air Cleaner and upon every HEPA filter replacement, roll the
HEPA Filter Change Calendar ahead 1 to 3 years to indicate when filter replacement is
necessary.
NOTE: Changing the Filter Replacement Reminder wheels can only be accomplished by
removing the back grille from the front housing. The filter replacement month and year are
displayed through the two windows on the top of the control panel.
) and unplug from the power supply.