Specifications - AirTap ATI50 Technical Manual

SPECIFICATIONS

A. SPECIFICATION TABLE
B. POWER CONSUMPTION DATA FOR KEY COMPONENTS
Component
Compressor
Fan Motor
Electric Heater (Primary/Back-up)
C. MAIN WIRING PORT
The unit is to be hard-wired to a 240V, 30A outlet using a flexible conduit with a conduit connector. Locate the main
wiring port. There are three 10AWG wires within the main wiring port with soldered ends: L1, L2 and G (the G or
Ground wire is the yellow/green wire).
1. Remove the main wiring port access cover.
2. Feed the external electrical wires through the wire pass through by unfastening the out cable ring.
3. Connect these wires to the external electrical wires using insulated butt splice connectors or wing nuts (not
included). Ensure that:
A. External wires have a 10AWG rating
B. Butt splice connectors or wing nuts have the correct rating to connect two 10AWG wires. If wing nuts are used:
i. Use #10 red wing nuts for copper to copper connections or #10 purple wing nuts for copper to aluminum
connections.
ii. Clip the soldered ends of the unit's wire and strip the insulation sheath adequately to avail unsoldered wire
ends.
4. Place the wires back in the unit, replace the access cover and fasten the outer cable ring around the exiting wires.
SPECIFICATIONS (Models ATI50, ATI66 and ATI80)
Power supply
Frequency
Electric outlet rating
Heat pump output (ambient temp 68F)
Primary electric heater output
Back-up electric heater output
Maximum water temperature
Maximum current
Make
Model
Type
Current rating
Refrigerant
Pressure
Suction tube ID
Discharge tube ID/OD
Input voltage (V) Input power (W) Current (A) Max power (W)
PCB
220-240V AC Single Phase
COMPRESSOR
Hermetic Motor (Rotary)
HP:4.2MPa LP:0.2MPa
Tab. 1
220 790
220 78
220 2.5
220 4000
Tab. 2
4
60Hz
30A
2.75kW
4kW
4kW
135F
23A
Panasonic
5RS080FBA21
3.6A
R410A (17.6 oz)
9.7mm
6.53/9.53mm
3.6
0.35
0.011
18.1
1100
90
3.5
4200