ecofires eko 2050 Installation & User's Instructions page 15

Inset decorative gas fire
Table of Contents

Advertisement

8.2 FUEL BED LAYOUT (LOG EFFECT)
1. Refer back to section 6.0 - Fuel bed layout (coal effect option) and fol-
low steps 1 and 2. The fuel effect matrix used for log effect versions is
the same design as coal effect versions, but has a different surface finish.
The front log strip is of a different design and must be handled with care.
Position them as shown in figure 18.
2. Open the bag of 9 moulded ceramic logs. All of the logs except two
are the same.Take the largest log (numbered 16) and place it as shown.
Care should be taken to ensure that the orientation is correct and the
log fits snugly into its position.
3.Take the two medium sized logs (numbered 15 and 8) position the log
numbered 8 on the left hand side as shown in figure 20, ensuring correct
orientation. Place the log numbered 15 on the right hand side as also
shown in figure 19, again ensuring correct orientation. Both these logs
will fit securely into their allocated position, they may require rotating
slightly to ensure this.
4. Now take the remaining large log (numbered 4) and position vertical-
ly as shown in figure 21, ensuring correct orientation.The base of this log
must rest securely on the front log strip. Take one of the smaller logs
(numbered 14) and position in between the two vertically positioned
logs ensuring the orientation is correct. Keep the spacing between these
logs uniform.
5. Finally, take the remaining two medium sized logs (numbered 5 and 7)
and place in a horizontal position shown, 5 first, resting on the front log
strip. 7 next resting on 5. Now take the smallest log (numbered 12) and
position in the orientation shown ensuring the log does not fall into the
matrix but rests securely on the allocated supports. Now take the final
log (numbered 14) and place in a horizontal position as shown. Ensure
there is even spacing between the logs and rotate if necessary to provide
a stable fit onto the matrix.The fuel bed layout is now complete.
IMPORTANT : The fire is designed to operate correctly with
the logs supplied when assembled according to the instructions.
Never add to the nine logs, or change them for a different type.
Never throw rubbish or other matter onto the fuel bed.
Figure 18
Figure 19
Figure 20
Figure 21
Figure 21
7
GB IE
2011 Focal Point Fires plc.
'

Advertisement

Table of Contents
loading

Table of Contents