Advertisement
Operating Instructions for the Globalstar GSP-2900 "Fixed" satellite phone
This fixed site satellite phone is designed for in-building use and interfaces with a standard analog
telephone set for control of all its functions.
1. To place a call, lift the handset and confirm there is dial tone. Dial the number by dialing 1, area
code and the seven digit phone number. (It is a long-distance call to and from any number you
call.)
•
Do NOT dial a 9 before the 1+ 10-digit number, unless your phone is wired into your
PBX (switchboard) This will result in a call failure.
•
DO dial the 1 +area code+ seven-digit number.
2. Wait at least 30 seconds for the call to connect to the satellite and back down to the destination
phone number. This is called latency – it takes longer than a cell phone or land-line phone to
connect.
3. If you get a fast-busy signal, this usually indicates that there is no satellite within range of the
antenna. Hang up and wait 2-3 minutes. Try your call again.
4. If you need assistance, have questions, or want to report a problem, call the Customer Care
service desk at the number below, or contact the installation vendor that installed your phone.
Customer Care 1-877-452-5782
Or enter *611 from the telephone keypad.
Roof-top antenna
Advertisement
