Input Label; Input Skip - Sharp Aquos LC-32M400X Operation Manual

Setup menu (Continued)
Parental rating
This function allows TV channels to be restricted.
It prevents children from watching violent or sexual
scenes that may be considered inappropriate.
1 Repeat steps 1 to 3 in Setting a password.
Press a / b to select "Parental rating", and
2
then press ENTER.
Press a / b to select your desired rating,
3
and then press ENTER.
When the country setting is set to "Australia".
Selected item
General and Content is not offensive to most viewers.
above (G)
Parental Content is such that parents may
guidance and not want their children to view the
above (PG) programme.
Mature and Mature audience only. This programme
above (M) is specifi cally designed to be viewed by
adults and therefore may be unsuitable
for children under 15.
Mature adult Mature adult only. Mature audience only.
and above This programme is specifi cally designed
(MA) to be viewed by adults and therefore may
be unsuitable for children under 15.
Adult Not for children under age 15. Strong
violence and elements of sex and/or violence.
above
(AV)
Restricted Not for children under age 18. Strong
and above (R) elements of sex and/or violence.
No block (–) Cancel the blocking.
When the country setting is set to "New Zealand" or
"Singapore".
Block 5 age and below
Block 11 age and below
Block 13 age and below
Block 15 age and below
Block 17 age and below
Block 18 age and below
No block
H Input skip
This setting allows you to skip the HDMI or RGB
input on the input source selection operation.
INPUT1(HDMI)
INPUT2(HDMI)
INPUT3(HDMI)
INPUT7(RGB)
14
Description
Skip input selection of HDMI
Yes No
H Input label
You can assign each input source a label as you
prefer.
1
Press INPUT to select the desired input
source.
2
Press MENU and the MENU screen
displays.
Press c / d to select "Setup".
3
Press a / b to select "Input label", and then
4
press ENTER.
Press a / b / c / d to select a desired
5
alphanumeric, and then press ENTER.
Repeat until the name is fully spelt out.
Maximum 6 alphanumeric can be input.
External equipment name settings
A
KLMNOPQRST
U V W X Y Z + – . _
0 1 2 3 4 5 6 7 8 9
To exit, select END and then press ENTER.
If the wrong alphanumeric is entered, select
CLEAR to clear, and then press ENTER.
NOTE
• You cannot change labels if the input source is ATV and
DTV.
H Position
For adjusting a picture's horizontal and vertical
position.
Selected item
H-Position Centres the image by moving it to the left
or right.
V-Position Centres the image by moving it up or
down.
Reset Reset position to factory preset values.
H HDMI auto view (HDMI input mode only)
Selected item
Enable/ Set whether or not to use the Auto
Disable Selection of WIDE MODE based on signal
recognition received from the HDMI
signal.
H WSS
WSS allows a television to switch automatically
among the different screen formats. (On, Off)
NOTE
• Try to set the WIDE MODE manually if an image does not
switch to the correct screen format. When the broadcast
signal contains no WSS information, the function will not work
even if enabled.
• Not available for COMPONENT, PC and HDMI signal.
B C D E F G H I J
CLEAR
BACK
END
Description
Description