Appendix: Installing The Stand - Sanyo LCD-32XR11F Instruction Manual

If the stand is provided, please read these instructions thoroughly before attempting this installation.
You must install your TV into the stand in order for it to stand upright on a cabinet or other flat surface. If you intend
to mount your TV on a wall or other vertical surface, you must remove the stand column.
Cautions:
Make sure that you handle your TV very carefully when attempting assembly or removal of the stand. If you are not
sure of your ability to do this, or of your ability to use the tools necessary to complete this job, refer to a professional
installer or service personnel. The manufacturer is not responsible for any damages or injuries that occur due to
mishandling or improper assembly.
When using a table or bench as an aid to assembly, make sure that you put down a soft cushion or covering to prevent
accidental scratching or damage to your TV's finish.
The speaker is not intended to support the weight of your TV. Do not move or handle your TV by the speaker. This
can cause damage to your TV that is not covered by the manufacturer's warranty.
Before attempting assembly or removal of the stand, unplug the AC power cord.
Installing the stand
Locators
Stand base
NOTE:
The appearance of this product in these illustrations may differ from your actual product, and is for
comparative purposes only.

Appendix: Installing the Stand

To install the stand:
1. Remove the stand from the box and place it on a table or
2. Lay your TV flat (screen down) on the edge of a table or
Stand
column
3. Align the stand base with the TV, move the stand base
Screw holes
bench.
You must pay attention to the direction of the stand. The
wide portion of the stand should go towards the front of
the TV.
bench. Make sure that you put down a soft cushion or
cloth so that your TV is not scratched.
gently until the locators on the stand column align with
the locating grooves on the stand. And align the holes in
the stand with the holes in the stand column, then secure
the stand to the column with provided screws.
To remove the stand from the TV, just detach the
screws from the stand base.
39