Functional Description; Operation - Stanley Fat max Instruction Manual

1. Trigger switch

FUNCTIONAL DESCRIPTION

2. Lock-on button
3. Saw blade locking lever
4. Saw blade
5. Shoe sleeve
6. Shoe
7. Shoe beveling lever
8. Speed control wheel
9. Cutting action lever
10. LED Light

OPERATION

Before attempting any of the
following operations, make sure that the tool is
WARNING:
switched off and unplugged and that the saw blade
has stopped. Used saw blades can be hot.
- Push the saw blade locking lever (3) upward.
BLADE INSTALLATION (FIGURE B)
- With teeth facing forward, insert the shank of the
saw blade into the blade holder as far as it will go.
- Release the lever.
- Check to ensure blade is secure before cutting.
Never use the tool when the shoe is loose or removed.
ADJUSTING THE SHOE FOR BEVEL CUTS (FIGURE C)
The shoe plate can be set to a left or right bevel angle of up to 45°.
WARNING:
- Pull the shoe beveling lever (7) out and away from the saw to unlock the shoe (6) as shown in
To set the bevel angle:
- Slide the shoe forward to release it from the 0° positive stop
figure C.
position.
- The shoe can be beveled to the left or to the right and has
detents at 15°, 30° and 45°.
- Set the shoe to the desired bevel angle. Use a protractor to
verify angle accuracy.
- Push the shoe beveling lever back towards the saw to lock
the shoe.
- Pull the shoe beveling lever (7) out and away from the saw
To reset the shoe for straight cuts:
to unlock the shoe (6) as shown in figure C.
- Rotate shoe to an angle of approximately 0° and then pull
shoe backwards to engage the 0° positive stop.
- Push the shoe beveling lever back towards the saw to lock
the shoe.
SAVE THESE INSTRUCTIONS
A
8
10
9
3
4
B
C
5
2
1
7
6
5